Support for the ScatterWeb MSB-A2 board. More...
Support for the ScatterWeb MSB-A2 board.
The MSB-A2 is programmed via an ISP bootloader over UART. The board includes an FTDI USB-TTL converter, which is connected to the left USB Mini-B connector (see picture above). Connect the MSB-A2 using that connector to your PC and run from within the folder of your application to flash:
BOARD=msba2 make flash
You'll notice that during the first invocation takes a bit longer, as the tool
lpc2k_pgm used to flash the MSB-A2 is also compiled.
You can connect to the shell by running:
BOARD=msba2 make term
Some rigorous hardware modification is needed to access the JTAG interface of the MSB-A2.
The following wires need to be soldered on:
|JTAG-TDO||IC2, Pin 1|
|JTAG-TDI||IC2, Pin 2|
|JTAG-TMS||IC2, Pin 3|
|JTAG-TRST||IC2, Pin 4|
|JTAG-TCK||IC2, Pin 5|
|JTAG-RTCK (*)||IC2, Pin 100|
|RESET||right pad of R6 (easier to solder) or IC2, Pin 17|
|GND||The bottom left through-hole pad|
(*) You can safely omit the connection to JTAG-RTCK.
As debugger an FT2232HL is used, the cheapest version costs less 10€ (often nicknamed CJMCU-2232HL).
Connect as follows:
Once this is done, debugging is as simple as running:
BOARD=msba2 make debug
Theoretically you should be able to flash also via JTAG. But do not expect this to be faster. Also: Do you really want to risk bricking the MSB-A2 you spend so much time to modify? The author of this text surely didn't want to risk that...
|Basic definitions for the MSB-A2 board. |
|MSB-A2 peripheral configuration. |