Olimex MSP430-H2618

Support for the Olimex MSP430-H2618 board. More...

Detailed Description

Support for the Olimex MSP430-H2618 board.

MCU

MCU	TI MSP430F2618
Family	MSP430
Vendor	Texas Instruments
Package	64 QFN
RAM	8 KiB
Flash	116 KiB
Frequency	16 MHz
FPU	no
Timers	2 (2x 16bit)
ADCs	1x 8 channel 12-bit
UARTs	2
SPIs	2
I2Cs	1
Vcc	1.8 V - 3.6 V
Datasheet MCU	Datasheet MSP430F2618
User Guide MCU	User Guide MSP430F2xx
Datasheet Board	Datasheet Olimex MSP430-H2618
Website	Website Olimex MSP430-H2618

Warning

While erasing or writing to the flash, the MCU must be powered by at least 2.2 V

Schematics

Pinout

The 64 pins on the edges of the PCB are connected to the corresponding MCU pins. Hence, the following pinout of the naked MSP430-F2618 MCU chip matches the pinout of the header board:

Flashing RIOT

Connect the board to a JTAG debugger supported by mspdebug; by default the Olimex MSP430-JTAG-Tiny (as shown in the picture above) is assumed, which is among the less expensive options.

Note

If you are not using the Olimex MSP430-JTAG-Tiny (or a compatible programmer), set MSPDEBUG_PROGRAMMER to the correct value via an environment variable or as parameter to make. E.g. use make BOARD=olimex-msp430-h2618 MSPDEBUG_PROGRAMMER=bus-pirate to flash using the bus pirate.

Warning

You can power the board via the JTAG programmer by placing a jumper at P_IN. However, the JTAG programmer will only be able to provide a limited current. You may want to disconnect the header board from devices consuming a lot of power prior to flashing.

If the board is powered externally, make sure to place the jumper in P_OUT position, not in P_IN position.

A jumper in P_OUT is mutually exclusive to a jumper in P_IN. Never connect both at the same time.

Note

Pin 1 on the JTAG connector has a small white triangle next to it and square pad, compared to the round pad used by all other JTAG pins.

Warning

The Olimex MSP430-JTAG-Tiny will fail to flash or debug the board until the latest firmware is installed. For that, install the Windows-only programmer software and update the DLLs files to contain the latest firmware as described in the website. The software will update the programmer upon launch.

Once the jumper is correctly placed in either P_IN or in P_OUT and the JTAG cable is connected just run

make BOARD=olimex-msp430-h2618 flash

Using the shell

stdio is available via the UART interface with TXD = P3.6 (pin 35 on the header) and RXD = P3.7 (pin 34 on the header) at 115,200 Baud.

The easiest way is to connect an USB TTL adapter (such as the cheap cp210x or ch341 based adapters) as follows:

TTL adapter    Olimex MSP430-H2618
-----------    -------------------
 
       GND --- 63 (DV_SS)
       TXD --- 35 (P3.7)
       RXD --- 34 (P3.6)

Files
file	board.h
	Basic definitions for the Olimex MSP430-H2618 board.
file	periph_conf.h
	Olimex-MSP430-H2618 peripheral configuration.