Loading...
Searching...
No Matches
SODAQ ONE

Support for the SODAQ ONE board. More...

Detailed Description

Support for the SODAQ ONE board.

General information

General information about this board can be found on the SODAQ support website.

Flash the board

Use BOARD=sodaq-one with the make command.
Example with hello-world application:

make BOARD=sodaq-one -C examples/hello-world flash
Note
If the application crashes, automatic reflashing via USB, as explained above won't be possible. In this case, the board must be set in bootloader mode by double tapping the reset button before running the flash command.

Accessing STDIO via UART

STDIO of RIOT is directly available over the USB port.

The TERM_DELAY environment variable can be used to add a delay (in second) before opening the serial terminal. The default value is 2s which should be enough in most of the situation.

Files

file  arduino_iomap.h
 Board specific configuration for the Arduino API.
 
file  board.h
 Board specific definitions for the SODAQ ONE board.
 
file  gpio_params.h
 Board specific configuration of direct mapped GPIOs.
 
file  periph_conf.h
 Configuration of CPU peripherals for the SODAQ ONE board.