board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2017 Eistec AB
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once

 
#include "cpu.h"
#include "periph_conf.h"
 
#ifdef __cplusplus
extern "C"
{
#endif

#define LED0_PIN            GPIO_PIN(PORT_A,  1)
#define LED1_PIN            GPIO_PIN(PORT_A,  2)
#define LED2_PIN            GPIO_PIN(PORT_D,  5)
 
#define LED0_MASK           (1 <<  1)
#define LED1_MASK           (1 <<  2)
#define LED2_MASK           (1 <<  5)
 
#define LED0_ON            (GPIOA->PCOR = LED0_MASK)
#define LED0_OFF           (GPIOA->PSOR = LED0_MASK)
#define LED0_TOGGLE        (GPIOA->PTOR = LED0_MASK)
 
#define LED1_ON            (GPIOA->PCOR = LED1_MASK)
#define LED1_OFF           (GPIOA->PSOR = LED1_MASK)
#define LED1_TOGGLE        (GPIOA->PTOR = LED1_MASK)
 
#define LED2_ON            (GPIOD->PCOR = LED2_MASK)
#define LED2_OFF           (GPIOD->PSOR = LED2_MASK)
#define LED2_TOGGLE        (GPIOD->PTOR = LED2_MASK)

/* SW2, SW3 will short these pins to ground when pushed. Both pins have external
 * pull-up resistors to VDD */
/* BTN0 is mapped to SW2 */
#define BTN0_PIN            GPIO_PIN(PORT_C,  1)
#define BTN0_MODE           GPIO_IN
/* BTN1 is mapped to SW3 */
#define BTN1_PIN            GPIO_PIN(PORT_B, 17)
#define BTN1_MODE           GPIO_IN

#define FXOS8700_PARAM_I2C          I2C_DEV(0)
#define FXOS8700_PARAM_ADDR         0x1C
 
#ifdef __cplusplus
}
#endif