Texas Instruments SimpleLink(TM) CC1312 Wireless MCU LaunchPad(TM) Kit. More...
Detailed Description
Texas Instruments SimpleLink(TM) CC1312 Wireless MCU LaunchPad(TM) Kit.
Overview
The LAUNCHXL-CC1312R1 is a Texas Instrument's development kit for the CC1312R1 SoC MCU which combines a Cortex-M4F microcontroller alongside a dedicated Cortex-M0 to control radio.
Hardware
| MCU | CC1312R1 |
|---|---|
| Family | ARM Cortex-M4F |
| Vendor | Texas Instruments |
| RAM | 80KiB |
| Flash | 352KiB |
| Frequency | 48MHz |
| FPU | yes |
| Timers | 4 |
| ADCs | 1x 12-bit (channels) |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 1 |
| Vcc | 1.8V - 3.8V |
| Datasheet | Datasheet (pdf file) |
| Reference Manual | Reference Manual |
Board pinout
The LAUNXHL-CC1312R Quick Start Guide provides the default pinout for the board.
Flashing the Device
Flashing RIOT is quite straight forward. The board comes with an XDS110 on-board debug probe that provides programming, flashing and debugging capabilities through the USB Micro-USB connector. Once either TI Uniflash or OpenOCD are installed just connect the board using the Micro-USB port to your computer and type:
To use OpenOCD instead of uniflash we need to set the PROGRAMMER environment variable, this is to enable OpenOCD instead of Uniflash.
For detailed information about CC1312 MCUs as well as configuring, compiling RIOT and installation of flashing tools for CC1312 boards, see RIOT-OS on CC26xx/CC13xx boards.
Files | |
| file | gpio_params.h |
| Board specific configuration of direct mapped GPIOs. | |
| file | periph_conf.h |
| Peripheral MCU configuration for TI CC1312 LaunchPad. | |
