ESP32-Ethernet-Kit V1.0 Board

Support for for Espressif ESP32-Ethernet-Kit v1.0.

Support for for Espressif ESP32-Ethernet-Kit v1.0.

Author

Gunar Schorcht gunar.nosp@m.@sch.nosp@m.orcht.nosp@m..net

Erik Ekman eekma.nosp@m.n@go.nosp@m.ogle..nosp@m.com

Espressif ESP32-Ethernet-Kit V1.0

Table of Contents

1. Overview
2. Hardware
   1. Board Configuration
   2. Board Pinout
3. Other Documentation Resources

Overview

The Espressif ESP32-Ethernet-Kit is a development board that uses the ESP32-WROVER-B module. Most important features of the board are

• 100 Mbps Ethernet via IP101G PHY
• USB bridge with JTAG interface

Furthermore, some GPIOs are broken out for extension. The USB bridge based on FDI FT2232HL provides a JTAG interface for OCD debugging through the USB interface. For flashing and debugging the board, see ESP32-Ethernet-Kit common board documentation.

ESP32-Ethernet-Kit V1.0

Back to table of contents

Hardware

This section describes

• the default board configuration,
• the board pinout.

Back to table of contents

Board Configuration

ESP32-Ethernet-Kit v1.0 has the following on-board components

• 100 Mbps Ethernet via IP101G PHY
• USB bridge with JTAG interface

For detailed information about the configuration of ESP32 boards, see section Peripherals in RIOT-OS on ESP32 SoC Series Boards.

Note

Only a few GPIOs are broken out and available for external hardware on ESP32-Ethernet-Kit boards. Which GPIOs are available as peripherals depends on used modules.

Function	GPIOs	Remarks	Configuration
BTN0	GPIO0	not available if esp_eth is used
ADC	GPIO34, GPIO35, GPIO36, GPIO39		ADC Channels
DAC	-		DAC Channels
PWM_DEV(0)	GPIO4		PWM Channels
I2C_DEV(0):SDA	GPIO32		I2C Interfaces
I2C_DEV(0):SCL	GPIO33		I2C Interfaces
SPI_DEV(0):CLK	GPIO14	HSPI is used	SPI Interfaces
SPI_DEV(0):MISO	GPIO12	HSPI is used	SPI Interfaces
SPI_DEV(0):MOSI	GPIO13	HSPI is used	SPI Interfaces
SPI_DEV(0):CS0	GPIO15	HSPI is used	SPI Interfaces
UART_DEV(0):TxD	GPIO1	Console (configuration is fixed)	UART interfaces
UART_DEV(0):RxD	GPIO3	Console (configuration is fixed)	UART interfaces

Note

• GPIO4 only works properly on the board if the function switch for GPIO4 (DIP SW 5) is OFF.
• SPI_DEV(0) is not available if module esp_jtag is used. For the SPI_DEV(0) pins to work properly, the function switches (DIP switches) for the JTAG signals must be set to OFF.

Back to table of contents

Board Pinout

The board schematic can be found here.

By default, only 3 bidirectional GPIO pins are unused: GPIO4, GPIO32, GPIO33. The suggested configuration is for PWM and I2C, but they can also be used for SPI or another serial port. By disabling the JTAG interface on the board, another 4 GPIOs can be made available (GPIO12, GPIO13, GPIO14, GPIO15).

Back to table of contents

Other Documentation Resources

There is a comprehensive Getting Started Guide for the ESP32-Ethernet-Kit with a lot information about hardware configuration.

Back to table of contents