Texas Instruments SimpleLink(TM) CC1352P Wireless MCU LaunchPad(TM) Kit. More...
Detailed Description
Texas Instruments SimpleLink(TM) CC1352P Wireless MCU LaunchPad(TM) Kit.
Overview
The LAUNCHXL-CC1352P is a Texas Instrument's development kit for the CC1352P SoC which combines dual-band wireless MCU with integrated power amplifier.
Hardware
| MCU | CC1352R1 |
|---|---|
| Family | ARM Cortex-M4F |
| Vendor | Texas Instruments |
| RAM | 80KiB |
| Flash | 352KiB |
| Frequency | 48MHz |
| FPU | yes |
| Timers | 4 |
| ADCs | 1x 12-bit (channels) |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 1 |
| Vcc | 1.8V - 3.8V |
| Datasheet | Datasheet (pdf file) |
| Reference Manual | Reference Manual |
The board comes in two variants with different RF matching network on the 20 dBm PA output port:
- LAUNCHXL-CC1352P1: 868/915 MHz up to 20 dBm, 2.4 GHz up to 5 dBm
- LAUNCHXL-CC1352P-2: 868/915 MHz up to 14 dBm, 2.4 GHz up to 20 dBm.
Board pinout
The LAUNCHXL-CC1352P1 Quick Start Guide provides the default pinout for the board.
Flashing the Device
Flashing RIOT is quite straight forward. The board comes with an XDS110 on-board debug probe that provides programming, flashing and debugging capabilities through the USB Micro-USB connector. Once either TI Uniflash or OpenOCD are installed just connect the board using the Micro-USB port to your computer and type:
To use OpenOCD instead of uniflash we need to set the PROGRAMMER environment variable, this is to enable OpenOCD instead of Uniflash.
For detailed information about CC1352P MCUs as well as configuring, compiling RIOT and installation of flashing tools for CC1352P boards, see RIOT-OS on CC26xx/CC13xx boards.
Files | |
| file | board.h |
| Board specific definitions for TI CC1352P LaunchPad. | |
| file | gpio_params.h |
| Board specific configuration of direct mapped GPIOs. | |
| file | periph_conf.h |
| Peripheral MCU configuration for TI CC1312 LaunchPad. | |
