Board specific definitions for the SLSTK3701A starter kit. More...
Board specific definitions for the SLSTK3701A starter kit.
Definition in file board.h.
Include dependency graph for board.h: This graph shows which files directly or indirectly include this file:Go to the source code of this file.
Functions | |
| void | board_init (void) |
| Initialize the board (GPIO, sensors, clocks). | |
Xtimer configuration | |
The timer runs at 1000 kHz to increase accuracy, or at 32.768 kHz if LETIMER is used. | |
| #define | XTIMER_DEV (TIMER_DEV(0)) |
| #define | XTIMER_HZ (1000000UL) |
| #define | XTIMER_WIDTH (32) |
| #define | XTIMER_CHAN (0) |
Board controller configuration | |
Define the GPIO pin to enable the BC, to allow serial communication via the USB port. | |
| #define | BC_PIN GPIO_PIN(PE, 1) |
Push button pin definitions | |
| #define | PB0_PIN GPIO_PIN(PC, 8) |
| #define | PB1_PIN GPIO_PIN(PC, 9) |
LED pin definitions | |
| #define | LED0R_PIN GPIO_PIN(PH, 10) |
| #define | LED0G_PIN GPIO_PIN(PH, 11) |
| #define | LED0B_PIN GPIO_PIN(PH, 12) |
| #define | LED1R_PIN GPIO_PIN(PH, 13) |
| #define | LED1G_PIN GPIO_PIN(PH, 14) |
| #define | LED1B_PIN GPIO_PIN(PH, 15) |
| #define | LED0_PIN LED0R_PIN |
| #define | LED1_PIN LED1R_PIN |
Macros for controlling the on-board LEDs | |
| #define | LED0_ON gpio_set(LED0_PIN) |
| #define | LED0_OFF gpio_clear(LED0_PIN) |
| #define | LED0_TOGGLE gpio_toggle(LED0_PIN) |
| #define | LED1_ON gpio_set(LED1_PIN) |
| #define | LED1_OFF gpio_clear(LED1_PIN) |
| #define | LED1_TOGGLE gpio_toggle(LED1_PIN) |
Display configuration | |
Connection to the on-board Sharp Memory LCD (LS013B7DH03). | |
| #define | DISP_SPI SPI_DEV(0) |
| #define | DISP_COM_PIN GPIO_PIN(PA, 11) |
| #define | DISP_CS_PIN GPIO_PIN(PC, 14) |
| #define | DISP_EN_PIN GPIO_PIN(PA, 9) |
Temperature sensor configuration | |
Connection to the on-board temperature/humidity sensor (Si7021). | |
| #define | SI7021_I2C I2C_DEV(2) |
| #define | SI7021_EN_PIN GPIO_PIN(PB, 3) |
| #define | SI70XX_PARAM_I2C_DEV SI7021_I2C |
Core temperature sensor configuration | |
Connection to the on-chip temperature sensor. | |
| #define | CORETEMP_ADC ADC_LINE(0) |
| #define LED0_OFF gpio_clear(LED0_PIN) |
| #define LED0_TOGGLE gpio_toggle(LED0_PIN) |
| #define LED1_OFF gpio_clear(LED1_PIN) |
| #define LED1_TOGGLE gpio_toggle(LED1_PIN) |
1.12.0