STM32 B-U585I-IOT02A

Support for the STM32 B-U585I-IOT02A. More...

Detailed Description

Support for the STM32 B-U585I-IOT02A.

Flashing the device

The ST B-U585I-IOT02A board includes an on-board ST-LINK programmer and can be flashed using OpenOCD.

Note

The latest release (v0.11) of OpenOCD doesn't contain yet support for this board, so the source code version from upstream master must be cloned and built:

git clone https://git.code.sf.net/p/openocd/code openocd
cd openocd
./bootstrap
./configure --prefix=<installation directory>
make -j
sudo make install

Once the patched OpenOCD is built and installed, you can flash the board simply by typing

BOARD=b-u585i-iot02a make flash

and debug via GDB by simply typing

BOARD=b-u585i-iot02a make debug

Important notice: With GCC 10, the tests/sys/malloc application doesn't work. To use malloc, prefer GCC 9 which seems to work better.

Files
file	board.h
	Board specific definitions for the ST B-U585I-IOT02A board.
file	gpio_params.h
	Board specific configuration of direct mapped GPIOs.
file	periph_conf.h
	Peripheral MCU configuration for the ST B-U585I-IOT02A board.