Support for the SODAQ Autonomo board. More...
Support for the SODAQ Autonomo board.
SODAQ Autonomo is a board by SODAQ featuring a ATSAMD21J18A. The SAMD21 is a ARM Cortex-M0+ micro-controller. It has 256Kb of flash memory and 32Kb of RAM.
The Autonomo is available from the SODAQ shop.
|Frequency||up to 48MHz|
|Timers||6 (1x 16-bit, 2x 24-bit, 3x 32-bit)|
|ADCs||1x 12-bit (8 channels)|
|UARTs||max 6 (SERCOMs shared with SPI and I2C)|
|SPIs||max 6 (see UART)|
|I2Cs||max 6 (see UART)|
|Vcc||1.8V - 3.6V|
Please refer to this tracker to see which projects are work in progress and who is the contact person for this. Notice that the initial support for the Autonomo was based on samr21-xpro. At some point we will add a separate issue to track changes for this board.
|MCU||samd21||partly||Energy saving modes not fully utilized|
|UART||yes||two UARTs by now|
|ADC||yes||PA04 & PA05 disabled by default due to EDBG's use of them for UART, can be enabled from |
|RNG||no||no HW module|
Besides the SAMD21 the board has the following features:
|Compatibility||Arduino M0 compatible|
|Size||58.5 x 33.5 mm|
|Digital I/O Pins||16, with 12 PWM, UART, SPI and TWI (I2C)|
|Analog Input Pins||6, 12-bit ADC channels|
|Analog Output Pins||10-bit DAC|
|External Interrupts||Available on all pins except pin 4|
|DC Current per I/O pin||7 mA|
|EEPROM||Up to 16KB by emulation|
|Clock Speed||48 MHz|
|Debug||Serial Wire Interface|
|Communications||Bee compatible slot for communication modules with software switchable power|
|Storage||16Mbit Dataflash Module and Micro SD card holder|
|Power||5V USB power and/or 3.7V LiPo battery|
|Power switch||Software switchable power for connected devices up to 1A|
|Charging||Solar charge controller, up to 500mA charge current|
|LED's||Yellow charge LED and green LED on pin 13|
BOARD=sodaq-autonomo with the
STDIO of RIOT is directly available over the USB port.
TERM_DELAY environment variable can be used to add a delay (in second) before opening the serial terminal. The default value is 2s which should be enough in most of the situation.
To build software for the autonomo board we strongly recommend the usage of the GNU Tools for ARM Embedded Processors toolchain.
The default stack sizes have not been tuned properly yet. If in doubt why your application crashes try increasing the default stack sizes and use
ps to find out how much stack is being used. Tracked in https://github.com/RIOT-OS/RIOT/issues/2228
|Default timer configuration for SODAQ boards. |
|Board specific configuration for the Arduino API. |
|Board specific definitions for the SODAQ Autonomo board. |
|Board specific configuration of direct mapped GPIOs. |
|Configuration of CPU peripherals for the SODAQ Autonomo board. |